CARATBODY 10 ml

Caratbody 10 ml

Viscosity

Caratbody applies the unique technology of creating a semi-solid state gel of Hyaluronic Acid. Our product has high cohesiveness and viscosity so when injected it creates a pseudo capsule as an implant form that it is not easily dissolved through natural hyaluronidase by the body (mechanism of long-lasting effect).

Longevity

Increased concentration / Increased particle size

Semi-solid Gel type Caratbody

Removable

High hydrophilic capacity

Our product provides excellent volume effect through its high hydrophilic capacity and stable molecular structure even after high cross-linking rate

Statement for use & manipulation sequence

1.Check the packaging status and the content of the product.

2.Acquaint enough yourself with the manual.

3.Use sterilized and packaged product.

4.Remove the packaging carefully and take out the syringe.

5.Open the packaging and check the injected capacity in the syringe, and check if any distortion, crack, or damage of the appearance.

6. Select needle syringe which is fit to the position to be injected and open the cap of the syringe, and connect the needle of syringe In order to prevent contamination.

7.Inject this product into the dermis.

8.Dispose after the use of amount inside the syringe due to the selection of user.

9.For 1.1ml face filler product, Ultra-thin wall 25G 13mm injection needle (with 0.4mm if internal diameter) is recommended in case of the product that does not enclosed a needle.

10.During administration, it is recommended that the bevel of the end of needle should face upward, the shape of the needle can be seen from underneath the skin as the depth of the injection. meanwhile the silhouette of needle under the skin cannot be seen clearly and once the syringe is in place, slowly inject  while insert the needle into the skin as next, withdraw the needle at the same angle as insertion, do not push the plunger during the needle is withdrawn from the skin, to prevent caratbody leaking from the needle point.

To achieve the desired result, the injection should be into the deep dermis. If the injection is too deep or inner layer of the muscle, the hyaluronic acid will be degrades rapidly, causing the duration time to be shortened. If the injection is too light may result in bluish discoloration of the skin or bulging.

11.For 10ml body filler product, it is recommended to use 16 ~ 18G Cannula (Semi-permanent cannula). Insert cannula into the fat layer, then using a controlled shake and turning motion to breaks up the fat tissues and allowing the fat layer to make space before injection.

 Breast Augmentation

Injection should be done at the top part of breast. Do not inject from the bottom part of the breast, otherwise ptosis or sagging may occur.

Compositon

HA concentration 20 mg/ml

Ingredient: Sodium Hyaluronate Gel

Injection area: deep dermis, shallow subcutaneous tissue

Storage condition: Store at room temperature

Avoid direct sunlight.

Do not store with freezing.

Shelf life：36 months

Disclaimer

Actual product packaging and materials may contain additional and/or different ingredient, nutritional, or proper usage information than the information displayed on our website. You are responsible for reading labels, warnings, and directions prior to using or consuming a product. If you have food sensitivities or allergies, you should always read the actual product labels to confirm the safety of the product for your situation. Content on this website is for general reference purposes only and is not intended to substitute for advice by a physician, pharmacist, or other licensed health care professional. You should not use the information presented on this website for self-diagnosis or for treating a health problem.

Visit Manufacturer’s Site